Reply to thread

In my case, the helmet "held" it's shape pretty close, due to the fact of the dome being attached at the top, and the helmet "barrel" being connected together at the rear....however, the addition of the mandibles/cheeks will definately solidify the construction.:)

Rob


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top