Reply to thread

Hi, I'm new here and what you have done here is just amazing. I've been looking at doing something similar to this and I've been reading through this and maybe I missed something, but how does the bottom of the helmet hold it's shape once you've cut out the cheekbones and visor slots? or is that the point, it won't actually hold it's shape until you put the cheekbones and visor in?


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top