Reply to thread

Sorry, I am sooo late, I was so busy so I didn't visit TDH for so long.



All temp parts I used is are shown as little graphics, the inner surface I didn't use.



At 100 deg celsius (212 deg F) its just a little comfortable warm for the plastic ;), no burning will happen here, so there will be no smoke or smell at all.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top