Reply to thread

Message

You like it huge coffe aren't you? Can't wait to see your Mendalorian Empire!
How thick is the material? I use 1mm material only, I have many other material thicknesses available, but I like the 1mm most.

See here I bend the 1mm (0.04") material "cold" at 20 °C (68°F)

[ATTACH]11020[/ATTACH]

I could bend it even more it would not break very easy.

Compared to the 2mm material, about at the same tension force.

[ATTACH]11021[/ATTACH]

[QUOTE="digifett, post: 129013, member: 1937"] You like it huge coffe aren't you? Can't wait to see your Mendalorian Empire! How thick is the material? I use 1mm material only, I have many other material thicknesses available, but I like the 1mm most. See here I bend the 1mm (0.04") material "cold" at 20 °C (68°F) [ATTACH]11020.vB[/ATTACH] I could bend it even more it would not break very easy. Compared to the 2mm material, about at the same tension force. [ATTACH]11021.vB[/ATTACH] [/QUOTE]

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification