Reply to thread

You have done a spectacular job, and I am envious and inspired!  I made a vacuum forming machine, but now I am going to have to try the smooth-on plastic for my future helmet creation endeavors.  Amazing results!  I can't wait to see where you go from here!


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top