Reply to thread

So had some (rare) free time today! I wanted to finish this stuff up as my Clothear's flight suit and vest are being finished and will be in hand shortly!


I was able to epoxy and use a fiberglass repair kit to position the arm correctly. I also mounted the mannequin's stand hardware on my base which I hope to get primed and finished this week!


[ATTACH=full]135976[/ATTACH]

[ATTACH=full]135977[/ATTACH]

[ATTACH=full]135978[/ATTACH]


This thread is more than 49 days old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top