Reply to thread

Hm.  I'll give that a go.  My significant other finessed my brim pattern so it's sitting on the helmet a bit better.  It's also made of fun foam - even though it's lighter than the leather I have, it's closer in behaviour than the card stock was.  I think I may make the inner hole slightly smaller than the pattern but soak the leather so I can stretch it and form it.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top