Reply to thread

Ok, so I have a rather old pull of a helmet that I'm going to use, but I'm having a heck of a hard time getting a pattern for the brim.  I have the basic shape, but when I pull the cardboard pattern down over the helmet, it warps the brim and it just doesn't sit properly.


I'm guessing that I will have to stretch the brim leather to get the right shape a bit?  Does anyone have experience with this?


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top