Reply to thread

Found some time to do the install of the Boot Greeblies to the Boot Covers/Spats. My intention is to install grommets - Like how I did my Fett Flak Vest. If you recall I countersunk some nuts into the Boot Greeblie....

[ATTACH=full]224483[/ATTACH]


1. Got the work station situated and all tools needed are out!

2. Concentrating on my Left Boot Cover/Spat.

3. Lay down my paper template mark and cut out as the nut placements are not exact and eyeballed.

4. Installed the Grommets - the Grommets I used had zero wiggle room so I had to be exact with this.

5. Ensured the Bolts fit without issue - Screwed on the Boot Greeblie.

6. Showing you the reverse side.

7. Repeat for the Right Side Boot Cover/Spat - and here it is completed!

[ATTACH=full]224484[/ATTACH]


Both look really good - and this method ensures that they are not going anywhere - nor will they spin out of place. Next step is to slap some paint and weather these bad boys up a bit!


On another note, I got someone working on the Turtleneck Dickie/Neck Seal. Hoping that'll be done this next week!


More to come!


-Iron


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top