Reply to thread

Hi Bhunter222,

Thanks for getting back to me.

That makes sense, I thought I'd seen somewhere the teeth were added to the mask itself. So if you were going to sculpt the teeth initially, how would you recommend getting the clay out of the mold? Just a good old wash down or perhaps scrape/dig it out?


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top