Reply to thread

I've never actually dealt with a real Borden connector. 

When you buy it, do you have to cut it down to install it?

I mean obviously from the picture you have to disassemble it to get the inner 3-hole piece isolated.  But after that, do you have to cut it down?


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top