Reply to thread

Yep, you are correct. The trick is to make some joints in the fingers. I am going to cut some "v's" in the hose. Hard to describe, so I will do some pics. I saw someone do this is a thread long ago, not sure if I could find it again. So I can't take credit for the idea;)


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top