Reply to thread

Heres my set up. i used my MR stand as the head pole. just pulled it right off the base. i felt safe doing this cause my MR is moded & has no collector value to it. the rods uncut . it goes into the neck of the mannequin so if i do want it displayed on the stand base it can still be used for that. i drilled holes in the pole to adjust the head hight so that it looks right with the helmet on.


[ATTACH=full]15795[/ATTACH]


[ATTACH=full]15796[/ATTACH]


[ATTACH=full]15797[/ATTACH]


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top