Reply to thread

Why don't you make molds out of MDF and vacform the pieces you need ? you can also make molds and drape form expanded pvc (sintra) over them. This would give you the shape you want with no fillers and it won't weigh a lot either.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top