Reply to thread

find something similar in shape, cover it with a couple of layers of masking tape, and fiberglass over it.  Pull out the mold and you've got a hollow shape you can then apply a thin layer of filler on top.  My brother does this all the time on car audio applications.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top