Reply to thread

Mine didn't looked as good as I was expecting, it flares out a little at the bottom.  I think it is something to do with my resin printer leveling or settings.  A lot of my prints came out "squished" in a way, that I had to increase the scale on the Z-axis to make it look right, which I had to do the same for the model of my OCP Police helmet ear cap detail.  I still haven't printed one properly to use, I will post pics later. 


BTW, at how many degrees angle did you make your edge?  Mine is a tiny bit off from yours when I looked at them side by side during the creation process, I didn't fillet or chaffer it, just a straight angle after making the circle in 123D Design.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top