Reply to thread

I used my program of choice, Modo, but any 3d software should be able to do it as a boolean operation. I ended up using a solid stalk though because the Westaby module is self-contained. Happy to share my file if you need it, are you using the same helmet file?


This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top