Reply to thread

Not a strictly costume-related update but I did whip up a nice and simple wall mount for my helmet finally! As far as I can tell there are no cheap 1" PVC flanges available so I modeled something simple. I left one side flat in case I wanted to print it on its side but I figured printing it laying down would actually be more structural.


[ATTACH]226368[/ATTACH][ATTACH]226367[/ATTACH][ATTACH]226369[/ATTACH]


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top