Reply to thread

Boba Helmet 3D Model & Print WIP



Helmet is looking good so far Maw


Your helmet flare looks off to me though, bottom of the flare looks good but for me the helmet isn't wide enough around the brim and its over emphasising the flare.


Keep going, I really like how it's looking but at the end of the day it's your sculpt and you have to be happy with it


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top