Reply to thread

Mine is about 6 lbs.  You could probably drop it down to 4 if you did ABS, two walls, and 5% infill.  I used PLA, with four walls, and 20% infill...because PLA is considerably more brittle, but you don't have the warp /shrink factor.



Sent from my iPad


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top