Reply to thread

The only one I had trouble with, was the lower tank caps...they were a super tight fit.  Everything else was just the quirks of splitting files and fitting them together.  I'm lucky with the glue I used...bonded the parts within 10 seconds solid...allows me to work with corners and such while it hardens.



Sent from my iPad


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top