Reply to thread

i also agree which is why i want to spend my big money on the detailed pieces of the suit. if i had a welder i'd prolly start on a metal helmet, but alas i lack metal fabrication devices so i am stuck with plastic and fiberglass.....*sigh* anywho i FINALLY joined this forum...been viewing for the last month and i must say it is the finest in the land.


so any pointers or cheap trick u would be willing to share?


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top