Reply to thread

here is how i did. Personally at the beginning i had some trouble to fix the servo but this way, with screws, i can keep of the servo if i want. anyway there are a lot of stuffs inside, and expecially if you want to add the cooling fans, the space inside become smaller and smaller xD

PS: all the inner surface had industrial velcro so i can try different locations of the electronics stuff, batteries , fans etc...

[ATTACH]64344[/ATTACH] [ATTACH]64345[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top