Reply to thread

the kind words are very much appreciated brother!  i do a dark green over the base green though i do think it should be done the other way around. i could be totally imagining things but to me, the darker spots seem to somewhat coincide with the butt of the EE3 in many of the promo shots. there is a similar pattern on the left side of ROTJ ab plate, same place it is in ESB but the color underneath is lighter than the base color, opposite of ESB. 

pretty easy process.  i cut a little square off one of those green scouring pads, pull it apart a little to loosen the fibers then spray some, you guessed it, rusto hunt club green on a paper plate and dip the square in it. dab off any excess then lightly apply it to the armor in the right spots, turning the square applicator at different angles for every touch to make as inconsistent a pattern as possible.  less is more and its definitely better to build it up with multiple passes.  hope that helps!



Sent from my R2 unit


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top