Reply to thread

The collar and the back plate is hold together with screws: the screw is inserted from the inside of the back plate through the collar then holded together with the shoulder studs (the same method is used with the cod piece and the back belt).


[ATTACH]29771[/ATTACH] [ATTACH]29773[/ATTACH] [ATTACH]29772[/ATTACH]


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top