Reply to thread

Here are some pics of a recently arrived Bo Katan helmet (woo hoo!).  My kid was excited.  I went ahead and did a quick trim of the visor area (thank you dremel).  It will need a tad more sanding/trimming in the inside but I think it is a mighty fine helmet.  I am thinking for the rest of the build to use a unitard for the main body, then probably a heavy cotton for the vest as suggested in a previous post.  I am assuming 3mm sintra is the way to go for the armor plates.  My daughter is a tween so I am thinking of doing a standard mando DW pattern for the armor as opposed to giving cups.  I know Bo Katan has cups, but then she is also a grown woman (am I too worried about this?).  So I guess instead of a Bo Katan she'll be her lesser known little sister, Go Katan (or would No-Go Katan be more appropriate?) :)  Wish me luck!


[ATTACH=full]125512[/ATTACH]

[ATTACH=full]125513[/ATTACH]

[ATTACH=full]125514[/ATTACH]


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top