Reply to thread

Next I moved onto the trigger. The molded in one is way too fat and toy like, so it had to go. I sanded it off with my dremmel, added some epoxy putty to fill the hole and then finished with body filler and sanding. I modelled and printed a new trigger to be glued on after painting.


[ATTACH]203327[/ATTACH][ATTACH]203328[/ATTACH][ATTACH]203329[/ATTACH]


The toy blaster also has a solid hammer where the screen used blaster has a hole in it. I used a center punch and stepped up drill bit sizes until I had the hole cleaned out. This was an area I knew to be hollow so when I added the resin in the earlier step, I made sure that it flowed back into this area to make it solid for drilling.

[ATTACH]203330[/ATTACH][ATTACH]203331[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top