Reply to thread

Message

Thanks for your input! When I'm talking about boat hull work I'm talking about doing them in a mold, the gelcoat goes in first then the inner layers so to speak.

Maybe we have different gelcoats in Europe, it's only when using it as a top layer that I know you have to mix in some wax to get it to cure properly.

As a side question, have you tried using epoxy resin for your fiberglass? Will it bond properly to the PU resin? As it's easier to work with indoors that hopefully will be my route.

Skickat från min Nexus 5 via Tapatalk

[QUOTE="Tottofagrin, post: 413754, member: 8606"] Thanks for your input! When I'm talking about boat hull work I'm talking about doing them in a mold, the gelcoat goes in first then the inner layers so to speak. Maybe we have different gelcoats in Europe, it's only when using it as a top layer that I know you have to mix in some wax to get it to cure properly. As a side question, have you tried using epoxy resin for your fiberglass? Will it bond properly to the PU resin? As it's easier to work with indoors that hopefully will be my route. Skickat från min Nexus 5 via Tapatalk [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification