Reply to thread

Hey! Thanks. I mulled over what you suggested for a while, did a little more research and decided to go for it. I did it very gently and only for a little bit and the resin definitely complied without breaking. Im about 90% of the way there. I’ll do another round of heat and bending tonight and see if I can get her straight as an arrow. Thanks for the advice!


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top