Reply to thread

Message

I did get a few pictures. I have a demonstration for how I hook up the knee armor. I used JB Weld to fasten snaps on the inside of the of the knee armor. I then fastened snaps onto elastic, and fastened a buckle to the other end of the elastic. Here is what I've got ... I hope it helps.

This picture shows one of the slits in my jumpsuit as well as the zipper running down the back of my leg:
[ATTACH=full]84161[/ATTACH]

And this picture shows how I attach the knee armor. I feed the buckles on each end of the elastic through the slits, then connect both end of the buckles, and then zip the zipper to keep it hidden:
[ATTACH=full]84162[/ATTACH]

[QUOTE="Jimmy BufFETT, post: 116822, member: 1286"] I did get a few pictures. I have a demonstration for how I hook up the knee armor. I used JB Weld to fasten snaps on the inside of the of the knee armor. I then fastened snaps onto elastic, and fastened a buckle to the other end of the elastic. Here is what I've got ... I hope it helps. This picture shows one of the slits in my jumpsuit as well as the zipper running down the back of my leg: [ATTACH=full]84161[/ATTACH] And this picture shows how I attach the knee armor. I feed the buckles on each end of the elastic through the slits, then connect both end of the buckles, and then zip the zipper to keep it hidden: [ATTACH=full]84162[/ATTACH] [/QUOTE]

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification