Reply to thread

I only suggested it because this isn't an extremely inticate mold. Your best bet would still be the silicone mold just because of the small recessed areas at the front (the whole for the led, etc.). But I make fiberglass molds when I cast parts for motorcycles such as seats or covers for a hot surface. It's good for making carbon fiber parts, which I doubt you'll make carbon fiber gauntlets but HEY! You never know right?;)


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top