Reply to thread

Message

I managed to snag a Casio MQ-1 for this project! The trick to opening it up after unscrewing lies in this little plastic latch which basically just needs to be forced. No damage thankfully.

[ATTACH]67190[/ATTACH]

Here's the circuit-board used in the keyslots behind the helmet.

[ATTACH]67191[/ATTACH]

A comparison between the RafalFett 3D model of the keypad (from Shapeways) and the real deal.

[ATTACH]67189[/ATTACH]

Mold making commenced and I soon had casts of both the MQ-1's face and the battery cover, which I'll be using on the left gauntlet master.

[ATTACH]67192[/ATTACH]

[QUOTE="Artakha, post: 410296, member: 7739"] I managed to snag a Casio MQ-1 for this project! The trick to opening it up after unscrewing lies in this little plastic latch which basically just needs to be forced. No damage thankfully. [ATTACH]67190.vB[/ATTACH] Here's the circuit-board used in the keyslots behind the helmet. [ATTACH]67191.vB[/ATTACH] A comparison between the RafalFett 3D model of the keypad (from Shapeways) and the real deal. [ATTACH]67189.vB[/ATTACH] Mold making commenced and I soon had casts of both the MQ-1's face and the battery cover, which I'll be using on the left gauntlet master. [ATTACH]67192.vB[/ATTACH] [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification