Reply to thread

Thanks for all the tips everyone! I should have specified, that last picture shows it overlapping because I have not cut it yet. I was wondering if it was going to look right or not before cutting off too much. I am planning on doing the shim for going seamless. Oh man I can't imagine trying to cover up an overlapping bit. I have scrap ABS I have been keeping since I started trimming the parts to my size. I should have this arm part all trimmed up tomorrow and I'll maybe get to work on the shim and bondo. Predatormv told me to get the gold version of bondo instead of the regular stuff, so hopefully that will let things move along a bit easier. I've worked with bondo before, so I'm not too scared, lol.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top