Reply to thread

Message

If you wanna do those arms justice, you need to shim the pieces instead of overlapping. It minimizes the amount of bondo you need to use. Use about a 1 inch wide piece of abs and glue it underneath the joint where the upper and lower halves meet when they are butted together. You can also use a for sale sign instead of ABS if you have no scrap ABS. I used the same method for my clone armor.....arms and legs both. Now the cod piece and butt plate...that's a whole different animal entirely.

[QUOTE="FlukeStarbucker, post: 231885, member: 2283"] If you wanna do those arms justice, you need to shim the pieces instead of overlapping. It minimizes the amount of bondo you need to use. Use about a 1 inch wide piece of abs and glue it underneath the joint where the upper and lower halves meet when they are butted together. You can also use a for sale sign instead of ABS if you have no scrap ABS. I used the same method for my clone armor.....arms and legs both. Now the cod piece and butt plate...that's a whole different animal entirely. [/QUOTE]

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification