Reply to thread

Message

Hey everyone, this new Clone Trooper area sure is sweet!

Alright, so I got a question on the lower arms for an Ep3 clone trooper. I have a Glover kit, not sure if that's the right abbreviation, but moving on, I'm trimming up some arms and wondering how much space there should be between the arms and the armor. Here's a picture to show you all what I'm talking about...

I'm going seamless, so I would like to get it all right before I start the bondo and sanding. Thanks everyone!

[ATTACH=full]16165[/ATTACH]

[ATTACH=full]16166[/ATTACH]

[QUOTE="askywalker98, post: 231878, member: 391"] Hey everyone, this new Clone Trooper area sure is sweet! Alright, so I got a question on the lower arms for an Ep3 clone trooper. I have a Glover kit, not sure if that's the right abbreviation, but moving on, I'm trimming up some arms and wondering how much space there should be between the arms and the armor. Here's a picture to show you all what I'm talking about... I'm going seamless, so I would like to get it all right before I start the bondo and sanding. Thanks everyone! [ATTACH=full]16165[/ATTACH] [ATTACH=full]16166[/ATTACH] [/QUOTE]

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification