Reply to thread

Message

For my wife's DP97, I used the Bondo brand fiberglass cloth and fiberglass mix. First, I ran really hot water in it while it was upside down to get the plastic soft and get the form I wanted. Then ran cold water in it to displace the hot and cool it off to retain the form. Once that was done, I cut the cloth into strips, coated them with the mix and laid them in the helmet. Once it dried... Presto. The helmet is solid, not brittle and light enough for my little wife.

Wes

[QUOTE="Jango Wes, post: 25870, member: 225"] For my wife's DP97, I used the Bondo brand fiberglass cloth and fiberglass mix. First, I ran really hot water in it while it was upside down to get the plastic soft and get the form I wanted. Then ran cold water in it to displace the hot and cool it off to retain the form. Once that was done, I cut the cloth into strips, coated them with the mix and laid them in the helmet. Once it dried... Presto. The helmet is solid, not brittle and light enough for my little wife. Wes [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification