Reply to thread

Thanks for the insight Haunter.  I guess I'm just hoping that the regular DP95 fits better due to a number of factors:

1.  The fibreglass and gelcoat on the recast were pretty thick (It was a really well done helmet and it pained me to sell it)  whereas the vinyl will hopefully be a little thinner all around.

2.  The recast had been stretched a bit (I'm guessing) to give it more flare which should have taken away from the front to back space. The recast had lots of space side to side but the cheek areas came up short on my forehead.

3.  I am hoping that by reinforcing the areas with lots of space and leaving the tight areas clear, I can have both space and support.


and lastly, the regular DP was all I could afford right now and should be decent for a "in the meantime" bucket.  Besides, when i upgrade I'll sell the painted bucket on Ebay for more than I paid for it.  ($50 for a DOP 95 was too sweet a deal to pass up)


Wish me luck!!!


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top