Reply to thread

OK, what the heck am I doing wrong here?  I'm painting a set of armor for a friend of mine... using the layered effect.

 

I sanded it, primered it, silver coated, yellow and was applying the green.  All of a sudden ALL the green paint started to crackle up and is completely RUINED!  Why the heck is this happening????

 

Now I've got to go back to square one with this crap... sand it all down and start over... WHAT A MAJOR PAIN IN THE REAR!  I should be done right now but instead have to start all over!  I feel like throwing it in the trash but I can't since it's not even mine.  UGH!!!!!!!!!

 

Any suggestions?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top