Reply to thread

Message

thanks for the tip. I think the excess material around the visor may be why I'm having such a hard time installing one.

I just got my targeting system all set up. Now I just need to figure out how and where I'm going to install it. The targeting system is really 4 AAA batteries, a switch, and small circuit board with 2 LEDs built in, some sintra, and an aesthetic circuit board on top that controls the lights in my RF. The lights on the inside blink when it's on so I know without having to lower the RF or take off my helmet or anything. It looks pretty cool too. You can kinda make out the LEDs in the last pic

[ATTACH=full]90588[/ATTACH]
[ATTACH=full]90589[/ATTACH]
[ATTACH=full]90590[/ATTACH]

I also redid a little bit of weathering near the visor and RF

Before
[ATTACH=full]90591[/ATTACH]
After
[ATTACH=full]90592[/ATTACH]

<blockquote data-quote="Apollo" data-source="post: 172891" data-attributes="member: 2460">thanks for the tip. I think the excess material around the visor may be why I&#039;m having such a hard time installing one.I just got my targeting system all set up. Now I just need to figure out how and where I&#039;m going to install it. The targeting system is really 4 AAA batteries, a switch, and small circuit board with 2 LEDs built in, some sintra, and an aesthetic circuit board on top that controls the lights in my RF. The lights on the inside blink when it&#039;s on so I know without having to lower the RF or take off my helmet or anything. It looks pretty cool too. You can kinda make out the LEDs in the last pic[ATTACH=full]90588[/ATTACH][ATTACH=full]90589[/ATTACH][ATTACH=full]90590[/ATTACH]I also redid a little bit of weathering near the visor and RFBefore[ATTACH=full]90591[/ATTACH]After[ATTACH=full]90592[/ATTACH]</blockquote>

[QUOTE="Apollo, post: 172891, member: 2460"] thanks for the tip. I think the excess material around the visor may be why I'm having such a hard time installing one. I just got my targeting system all set up. Now I just need to figure out how and where I'm going to install it. The targeting system is really 4 AAA batteries, a switch, and small circuit board with 2 LEDs built in, some sintra, and an aesthetic circuit board on top that controls the lights in my RF. The lights on the inside blink when it's on so I know without having to lower the RF or take off my helmet or anything. It looks pretty cool too. You can kinda make out the LEDs in the last pic [ATTACH=full]90588[/ATTACH] [ATTACH=full]90589[/ATTACH] [ATTACH=full]90590[/ATTACH] I also redid a little bit of weathering near the visor and RF Before [ATTACH=full]90591[/ATTACH] After [ATTACH=full]90592[/ATTACH] [/QUOTE]

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification