Reply to thread

Message

Gah! I forgot I had a thread up over here. I've been working on the helmet recently since I got in my T-visor and my Range finder and stalk came in from BM. I'm wiring a couple of LEDs into the RF and it's looking pretty good. The RF really brings the helmet together. Once these are installed I can start on the inside!

With the T-visor duct taped in
[ATTACH=full]90581[/ATTACH]
[ATTACH=full]90582[/ATTACH]

Some WIP with the RF.
[ATTACH=full]90583[/ATTACH]
[ATTACH=full]90584[/ATTACH]
[ATTACH=full]90585[/ATTACH]
[ATTACH=full]90586[/ATTACH]

I want to install my visor with Chicago screws but I don't know where to get those. Can anybody help me out with that?

[QUOTE="Apollo, post: 172884, member: 2460"] Gah! I forgot I had a thread up over here. I've been working on the helmet recently since I got in my T-visor and my Range finder and stalk came in from BM. I'm wiring a couple of LEDs into the RF and it's looking pretty good. The RF really brings the helmet together. Once these are installed I can start on the inside! With the T-visor duct taped in [ATTACH=full]90581[/ATTACH] [ATTACH=full]90582[/ATTACH] Some WIP with the RF. [ATTACH=full]90583[/ATTACH] [ATTACH=full]90584[/ATTACH] [ATTACH=full]90585[/ATTACH] [ATTACH=full]90586[/ATTACH] I want to install my visor with Chicago screws but I don't know where to get those. Can anybody help me out with that? [/QUOTE]

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification