Reply to thread

Has anyone had their knee armor crack/break on them?  I was prepping my right knee for primer by wet sanding in the sink (much to my wife's dismay :D).  It stated to crack near the narrow part on the side of the knee darts.  It did not break all the way through but enough to worry me.  Is this normal and if so can I expect this to occur in the future?


I am planning on buying an automotive FG repair kit and reinforcing the knees from behind.


I was wondering if anyone has had a similar experience and how you fixed it?


Thanks in advance,


Loranar


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top