Reply to thread

I am going to try this route. Maybe get it to fit in an "altoids" type tin. I will glue it inside the helmet, but unseen.


Amp: https://www.adafruit.com/products/987

Microphone: https://www.adafruit.com/products/1063

Battery holder: https://www.adafruit.com/products/771

Speaker options: https://www.adafruit.com/categories/271


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top