Reply to thread

Hey, Im in the same boat as you, but I think one way of doing it is making the sculpt out of some hard clay, make a plaster mould of it, and then using that plaster mould, cast the vacu-form mould out of resin or some hard material of the sort...


-tubachris


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top