Reply to thread

Thanks for the compliments!


My Fett is currently paused, as there is some work to be done, and the people who are doing it are on a well deserved vacation..


But, still...


More work on the Tusken.


There is talks of many future Tuskens for Finland, and to that end, I borrowed some Plastiline, and set out to make our own vac for buck. Not that there is anything wrong on the ones currently available, but with these anyone wanting a mask does not need to wait for runs or shippings. And, it gives me the opportunity to give back something, and try my skills.



I had the advantage of Studio Creation mask, and the pictures on the internet on my sculpt.



Few hours on the morning, and the basic sculpt is beginning to resemble what it should be. The red eye thingies are spools from a trheading machine, they are right sized, and there is abdundant supply of them. Just need to be thickened and sanded smooth..



Sideways, this is a problematic as I cannot tell from the sculpt if it is correct. Taking a picture and comparing it helps on the matter greatly. As I was working on the Ecto - 1 model, I could not see that the roof I was making was not formed that good, and afer taking pictures from the side, I could tell that more sanding was needed.



Ugly, yes, but getting there. Next to the SC version.


What do you think? I know that the rims around the eyes could be a little smaller, that can be done easily...


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top