Reply to thread

That doesn't look like a hand-schuab helmet.   It looks too 'clean'.  Because HS's helmets were cast in aluminum, there is some minor pitting in them that needs to be sanded down, and they don't look quite as crisp and sharp as the helmet you have posted.  As others have stated, you helmet looks to be cold-cast. 


HS's helmets are metal all the way through, and weigh about 5-6 lbs.   Much heavier than an FG or resin bucket.


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top