Reply to thread

Message

You're correct about the cost, around $30 a can. All you can do is prepare for as many costume pieces
as possible to be ready for each of the clear coat applications. You will use 2-3 cans for sure. I think the
Alumaluster cost was $150 -$200 for all of our armor, two helmets, part of his rifle, and the Armorers hammer
and I still have about a 1/4 of the pint left. Some of these extras used more 2K as well. All I can say is a good
costume is a lot of hard work and needs a good finish.

[QUOTE="Builder, post: 530224, member: 9056"] You're correct about the cost, around $30 a can. All you can do is prepare for as many costume pieces as possible to be ready for each of the clear coat applications. You will use 2-3 cans for sure. I think the Alumaluster cost was $150 -$200 for all of our armor, two helmets, part of his rifle, and the Armorers hammer and I still have about a 1/4 of the pint left. Some of these extras used more 2K as well. All I can say is a good costume is a lot of hard work and needs a good finish. [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification