Reply to thread

I've had Alumaluster rub off and I try not to touch it at all. I think it has very little

to bond to on top of the smooth 2K layer so the delicate nature of it just shows that you

are doing a good smooth job. Any liquid has a hard time sticking to a smooth surface. In the end

that's why the job can look so impressive and metallic. I really have enjoyed working with it.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top