Reply to thread

I take them into Inkscape and resize them to fit the helmet....print them out after many attempt of resizing then trace with tracing paper and apply the trace with a carbon paper...its alot of work but its the best way to get the stencil in the right spot.


The bone color may be close...but looks light on the screen at least looks closer to earth (ear color)


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top