Reply to thread

I have the armor files all printed, mounted and ready to cut, but I can't find the layout for the helmet.

Yes the paint stencils will open for me, but for the life of me I can't get Rafalfett's template to open.It keeps giving me an error when I try to open the page.


I found it!!


Thanks for responding though hvacdon


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top