Reply to thread

I use my 30 gallon Craftsman shop compressor. I have it setup with 2 outputs, each with a regulator. One for airbrush and one for everything else. I don't use a moisture trap. I have 2 airbrushes- a cheap Testors single action and a Badger 150 double action. Cleanup is a little longer with the Badger, but only like 5-10 minutes. I just clean right away when I am finished. I only run water based through it so far, oil based would probably be a longer clean up.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top